Driver gets stuck in newly-poured concrete

Crews were widening the road and had poured concrete down, which the driver of this vehicle apparently didn't notice.
August 16, 2011 3:50:08 PM PDT
Traffic jams are nothing unusual during the morning rush, but one logjam Tuesday morning in the Upper Kirby area wasn't your typical traffic tie-up.

A driver who was trying to make a U-turn on Kirby near the Southwest Freeway apparently didn't notice newly-poured concrete and drove right into it. Crews in the area had been widening the road and laid new concrete over sewer lines.

The stuck car caused a traffic mess in the already-congested area for about half an hour. Crews brought in a flatbed tow truck to pull the car out.


Load Comments